Patron T8, Operator'S Manual

Page: 12 / 41

- 8 -
2. Product Description
2.1 Introduction
Skin laser treatment instrument host, laser/laser joint arm/ laser power/ cooling
system/display control system
Laser cavity when laser can produce high voltage pulse xenon lamp and YAG crystal
bar. When laser xenon lamp injection of xenon lamp light after a certain amount of
energy, stimulate the YAG crystal rods to launch the 1064/532 nm laser, polaroid is
emitted laser unified to the same direction, make the emitted laser single better. After
laser in the laser cavity, before the mirror, mirror of the laser resonant part, after short
time trigger Q crystals, again after two 45-degree mirror reflection by emitting laser
light arms. In the process of laser xenon lamp in the light of have a large amount of heat
produced; After water circulating system will be hot.
Commonly known as the light arm joint arm
：
Laser smooth is convergent laser focus, focus spot diameter of 2 ~ 10 mm. When laser
gathering isometric point contact with the skin convergence focal spot diameter is 1
mm, when not in contact with the patient position, adjust the laser convergence
isometric point and the distance between the patients with skin is adjust convergence
focal spot diameter, adjusting the laser gathering isometric point and the distance
between the patients with skin range from 0 to 3 mm, the corresponding convergence
focal spot diameter for adjustment, in 2 ~ 10 mm distance after short of effective
treatment. Laser light launched into mouth will into the laser light arm inside, and then
use locking device lock base.