• To operate the product forward, move the operation
control fully forward and release it.
• To operate the product rearward, move the operation
control fully rearward and release it.
• To stop the movement of the product, move the
operation control in the opposite direction in small
movements until the product is stationary.
• To change direction, turn the product around by the
handle.
Maintenance
Introduction
WARNING:
Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
General product maintenance
Before use,
each 10 h
Each 100 h
Each 6
months or
250 h
Yearly, each
500 h
Make sure that there are no fuel or oil leaks.
*
Clean the product.
X
Make sure that nuts and screws are tightened.
*
Examine the throttle control and the forward and reverse
control for damage.
*
Make sure that the forward and reverse control can
move smoothly.
*
Lubricate the forward and reverse control and the link-
ages of the controls.
*
Examine the safety straps for damage. Replace if it is
necessary.
*
Examine the vibration damping units for damage.
X
X
X
Examine the tension of the V-belt and look for damages.
Adjust or replace the V-belt as necessary.
X
X
X
Examine all rubber hoses and rubber elements for dam-
age. Replace if it is necessary.
X
X
Do a check of the hydraulic oil level.
X
X
Do a check of the battery terminals.
*
*
Replace the oil in the eccentric element.
X
X
12
1982 - 001 - 26.10.2022