3. Loose and remove these four
screws at the back of light. Then take
off the back cover of the light.
7. Installation is completed.
4. Insert three new alkaline D
size 1.5V batteries (not included).
Do not mix old and new batteries.
Make sure the polarity are all
correct.
5. Then close the back cover and
secure it by attached four screws.
6. Buckle the motion light into the
mounting bracket securely.
· Do not mix old and new batteries.
OPERATIONAL INSTRUCTIONS
Use only new alkaline D size batteries with 1.5V rating for replacement.
· Non-rechargeable batteries are not to be recharged.
BATTERY REPLACEMENT
1. Mode button switch:
Inserting the new batteries for the first time and push
Mode
button once the light will turn on and enter a "warm-up" period for about
15
seconds, then automatically entering into Auto Mode. At night, turns light ON automatically when motion is detected and turns light OFF
automatically in setting time after all motion is stopped.
Push
Mode
button once again. The light will enter ON mode. The light will turned on during the day or night.
This will allow a limited period of constant illumination.
Push
Mode
button once again. The light will turned off.
Push
Mode
button once again. The light will enter Auot mode again. Circle in order to change these mode.
2. Setting the sensor adjustment rotary switch as your desired setting before use.
TIME
: Determines the duration of the light once motion is detected: 30 seconds, 60 seconds or 120 seconds.
• Test: Allows the positioning of the light’s motion sensor to be tested day or night. Once the motion sensor is in the desired position,
attempt to trigger the light by moving in the intended detection zone.
If the light illuminates, the motion sensor is positioned correctly. You are now ready to move the switch to the preferred duration option.
The light will now only turn on in darkness at Auto mode.
SENSITIVITY
: Controls the distance of the range of motion detection: low, medium or high.
Adjust the head of light fixture toward to left or right direction to get the desired light direction.
Adjust the head of light fixture toward to up and down to get the desired light direction.
Sensor Range: Up to 9 m / 30 ft. x 180 degree spread (Varies with various environment).
Lumens output: 1,500 lumens / 5,000K (Max, use three new alkaline D size 1.5V batteries).
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION
Gently remove all parts from the package and lay them out on a smooth surface.
1. Place the mounting plate on the
chosen surface as shown and mark
the position of the 2 holes (The
hole distance is around 1.97inch /
5cm).
2. Use a power drill (not included) to
drill two 13/64 inch holes into the
mounting surface. Insert the plastic
archors (C) in the holes and fasten
the mounting bracket (B) onto the
wall with attached mounting
screws(D).
2
