MANUAL
21846
AILONET 100
6.6.2002
AILONET USER MANUAL
Done
Copyright
Patria Ailon Oy 2002. All rights reserved.
6/24
Figure 1 . Factory settings switch
is located on the back of Ailonet.
1.2.3 Switches
There are two switches located on the back of Ailonet. The
right-most switch is reserved for future use. The left-most
switch sets Ailonet into default factory mode in boot phase
erasing all user settings, installed plug-ins and any additional
information that is not part of Ailonet platform core software.
The switch can be used if the unit gets in a state where it
can’t be accessed normally. However,
it is not
recommended to use the factory settings switch unless
the unit is absolutely dead and cannot be accessed in
any other method.
In many cases prototype Ailonets
contain plug-in like additions tailored for customer use and these settings will be removed in factory
settings mode as well.
In order to set Ailonet into factory settings mode, the unit must be started with the factory settings
switch in down (ON) position. User defined settings done in factory settings mode are store nor-
mally, but the switch must be switched in up (OFF) position before the unit is restarted.
