11 | P a g e
PATON
®
VDI SERIES MINI DC MMA
PARAMETERS
VDI MINI
Rated power supply voltage 50/60 Hz, V
~230
Power supply voltage range, V
170 – 260
Efficiency coefficient, (at 150A)%
90
Welding current control range, A
20 – 150
Welding current at a load factor of
40%, for 5 minutes
100%, for 5 minutes
150 А
94 А
Maximum consumed power, kVA
5.0
Normal operating voltage for the manual
- arc welding process MMA, V
20.4 – 25.5
9. DELIVERY SET
1.
Welding unit with a power cable
– 1 pcs;
2.
The welding cable 3 m in length with electrode holder
– 1 pcs;
3.
The welding cable 2 m in length with grounding clamp
– 1 pcs;
4.
Shoulder-carry belt
– 1 pcs;
5.
Plastic case
„PATON
®
”
– 1 pcs;
6.
Operation manual
– 1 pcs.
10. TROUBLESHOOTING
FAULT
FAULT CAUSE
FAULT RECOVERY
No welding currents.
The power is switched on;
the unit state indicator does
not light
Power cable breakdown
Check the state of the power cable
Power supply voltage is
below 165 V
Connect the welding unit to the
power supply system with proper
voltage.
Power supply voltage exceeds
260 V
Connect the welding unit to the
power supply system with proper
voltage
Fault of the internal power
supply module of the welding
unit
Apply to the service center
No welding currents
The power is switched on;
the state indicator lights
green
Welding cables are not
connected
Check the state of electric
connectors
The grounding clamp is not
properly connected or is not
connected to the workpiece
Properly connect the grounding
clamp terminal to the workpiece
No welding currents
The power is switched on;
the state indicator lights
yellow
The temperature sensor has
actuated
Wait until the welding unit is
cooled. After cooling, the welding
unit switches on automatically
Insufficient supply of cooling
air
Provide sufficient supply of cooling
air
Fault or the temperature
sensor
Apply to the service center
