Paton StandardMIG -200, Data Sheet And Operating Manual

Page: 10 / 37

PATON StandardMIG MMA/TIG/MIG/MAG
-10 -
ATTENTION! When the machine is switched off and cools down after an
operation in cold season, condensate forms inside of it, so do not switch the
machine on again in less than 3...4 hours!!!
Therefore, do not switch the machine off in cold season, if you are going to
switch it on within 4 hours.
The machine must be placed to ensure free inlet and outlet of cooling air
through the vent holes on the front and the rear panels. Take care that metal dust
(for example, during emery grinding) does inhaust directly into the machine by the
cooling fan.
ATTENTION! The machine may be life‐threatening after a hard fall. So
place it on a stable, solid surface.
2.3 POWER CONNECTION
The welding machine of series design is rated for mains voltage of 220V (-
27%+18%) or for three‐phase mains voltage of 3х380V (
±
20%).
Attention! All manufacturer’s warranty liabilities become void if the
single‐phase machine is connected to mains voltage exceeding 270V! Such a
situation can occur with a very large phase voltage imbalance in a standard
mains or using non-standard connection.
In addition, manufacturer’s warranty liabilities become void if the mains
line has been connected by mistake to the neutral wire or to the source
earthing wire during connection of a three‐phase machine.
Mains connector, cross‐sections of power supply cables, and supply‐line fuses
must be selected on the basis of technical specifications of the machine.
2.4 MAINS PLUG CONNECTION
Mains plug shall correspond to supply voltage and current consumption of the
welding machine (see Technical specifications). In accordance with safety
practices, use a sockets with a
guaranteed earthing and in no case do not use a
neutral wire for these purposes!!!
ATTENTION! The power switch 14 is a signal button that blocks only the
power current of the welding machine, but does not completely de-energize the
internal electronics of the device. Therefore, according to safety precautions, do
not forget to remove the plug from the socket when reconnecting.