Patlite WIO-B1T, Instruction Manual

Page: 44 / 88

Wireless Control Unit
44
7. Operation
7.10.3. Mounting with Pole (Option)
The following is an example installation using two circular brackets (SZP-003W: option) and Pole N.
❷
❽
❸❾
❻
❼
⓫
❶
⓭
Hexagon Nut
with Flange
(M4)
Terminal Block
Connector
Direct Mount
Bracket
Pole
Tab
Water-proof ring
for pole
Confirm that the two tabs are
on the outside
Circular Bracket
Waterproof
gasket
Waterproof gasket
Binding Head Tapping
Screw (3 × 12)
Binding Head Tapping
Screw (3 × 12)
Circular Bracket
Water-proof ring
for pole
❺
❹
❿
⓬
Confirm that the two tabs are
on the outside
WIO Body Unit
Indicator
Head Cover
The top case and
bottom case
cannot be
removed from the
indicator
• There is an insertion direction. Refer to the diagram to the right.
• There is an insertion direction. Refer to the diagram to the right.
Attach the pole's water proof ring to the circular bracket.
❷
Attach the pole's water proof ring to the circular bracket.
❽
Insert the pole into the circular bracket.
❸
Insert the pole into the circular bracket.
❾
Tighten the circular bracket from the top with the bind
tapping screws (3 x 12) (2 pieces).
❹
Tighten the circular bracket from the bottom with the
bind tapping screws (3 x 12) (2 pieces).
❿
Attach the waterproof packing.
❺
Attach the waterproof packing.
⓫
Pass the wires through the circular bracket and pole.
⓬
Attach the direct mount bracket to the circular bracket.
❻
Tighten the circular bracket from the bottom with the
three hexagon nuts with flange.
❼
Recommended Torque 0.6 N
・
m
Recommended Torque 0.8N
・
m
Recommended Torque 0.8N
・
m
Rotate the WIO body unit counterclockwise and
detach from the direct mount bracket.
❶
Install the WIO body unit to the direct mount bracket
following the removal procedure in reverse order.
⓭
• Detach the bracket in the same way as the head cover described in
"7.13. How to Attach and Detach Additional Units" (
☞
page 73).
• Attach the bracket in the same way as the head cover described in
"7.13. How to Attach and Detach Additional Units" (
☞
page 73).
• Make sure the wires can pass through the circular bracket
and pole before work.