Setup
When pressed, the Memory Black Out button will flash red, and all lights being
played back within Memories will go dark (output intensity goes to zero
percent). Press the button again to restore lights to their previous intensity.
If you set a
to 2, intensity levels from that recorded (and active)
Memory will not be affected by the Memory Master.
Below the Memory Master is a Shift button
. The Shift button accesses
short cuts and special features which are described in Other Features
Left and Right Playback
Cognito provides two Playbacks, one located beside the Grand Master and
one beside the Memory Master. Each Playback consists of a Go button, a
Playback Master, and a Pause/Back button. Any Playlist may be assigned to
either Playback. A Playlist is a series of cues or ‘looks’ that have been previously
recorded. Although there are only two physical playbacks, you may have as many
Playlists active at a time as desired.
Once a Playlist is loaded (see
), press the Go
button to
advance the Playlist to the next cue. The Go button flashes green when a cue is
running, and glows solid green when the cue is complete.
Above the Go button is the Playback Master, which sets the overall intensity of
any light levels controlled by the active Playlist.
Above the Playback Master is a Pause/Back
button. Pressing the Pause
button while a cue is running will cause the fade to stop and the Pause button will
flash yellow. To resume a paused cue, press the Go button again.
While resting in a cue, press the Pause/Back button to fade back to the previous
cue.
To force a Playback to release (exit) a Playlist, press and hold the Shift
button then press the Playlist’s Pause/Back
button.
25
