15
Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631
•
cobiaboats.com
The bilge is designed to drain any water entering the inside of the hull. All hoses are
sealed and double clamped during construction. Continuous or periodic running of the
automatic bilge pump may be an indication of a hose leak or break in a seal and should
be investigated by a Cobia Dealer immediately. Refer to page 10 for further information
regarding bilge pump operation and maintenance.
Livewell System
The livewell system is designed to keep your
baitfish alive and strong for as long as possible.
This livewell provides a cool, clean, and oxygenated
environment that allows you to keep your baitfish
alive for long periods of time. To efficiently operate
your livewell, the following steps should be taken:
1.
Open livewell hatch.
2.
Install stand-up pipe snugly.
3.
Ensure livewell pump ball valve is in open position.
4.
Turn on livewell switch.
The livewell operates by pumping fresh seawater from the pump through an aerator
head into the livewell. Drainage is achieved through the grate on the top of the
standpipe, which, when unobstructed, will limit the water level to the standpipe’s
highest point. A shorter standpipe can be used to keep less water in the well. This
constant drainage keeps up water flow and allows for the removal of ammonia from the
livewell, therefore extending the life of your baitfish. To drain the livewell, switch off the
pump, close pump ball valve, and remove standpipe.
Livewell