PASI GEA24, User Manual

Page: 32 / 59

32
6.3.4.1 Selecting a geophone, the source or the trigger
The item you select (geophone, source or trigger) for which you want to display data can
be done in two ways:
- press one of the specific selection keys of a geophone (source, trigger, previous
geophone, next geophone);
- select the radio button on the identifier field of the geophone (id) and enter the
number using the keypad.
Specific keys allow you to select the source or the trigger or use the special keys "-" and
"+". To go to the previous or next in the list. This mode can be used even though a
different field has been selected using the radio buttons.
Using the numeric keypad you have to press the radio button of the relevant identifier
field, so that it is selected and you can enter the digits, afterwards you can enter the value
regarding the geophone you want using the numeric keypad. This procedure does not
allow you to select the source nor the trigger.
The display fields will report the parameter values configured for the selected item.
6.3.4.2 Changing the value of a parameter
Changing the value of a parameter can be done as follows:
- select the relevant geophone as described above;
- press the radio button for the parameter to be modified, the numeric value will be
highlighted;
- enter the new numerical value for the selected parameter, the previous numeric
value will be replaced by the number you entered. The new value is automatically
saved.
6.3.5 Changing parameters on all geophones
The window allows you to modify the parameters on all the geophones at the same time.
The change made in this way does not affect the source nor the trigger parameters and
these should be set separately.
Figure 10 shows an image of the window where a change to the parameter in position X
is being made