Partilink M43-H04H02, User Manual

Page: 9 / 24

7
7. Web Management
To control the video display system via the web UI, please connect a PC to M43-
H04H02 for accessing the web UI via Ethernet directly. You can either connect PC to
M43-H04H02
(a) via Ethernet cable (CATx cable with RJ-45 connector) directly or (b)
via an Ethernet hub/Router with CATx cable between PC and M43-H04H02.
Before running web management or serial port control, please login from web or serial
port control.
7.1 IP Setting & Web UI Login
Access Web UI via Ethernet able or Ethernet hub/router, please follow steps
below to configure your PC Ethernet IP setting FIRST!
a.
Click “Start” > “Control Panel” > “Network and Sharing Center”
b.
Click “Change Adapter Settings”
c. Highlight the network adapter you want to use for connecting to the device
and click “Change Settings” of this connection.
The “Local Area Connection Properties” window for the selected network
adapter
d. Highlight the Internet Protocol Version 4 (TCP/IPv4)
e.
Click “Properties”. The Internet Protocol Properties window is relevant to
your IT system
f. Select
“Use the following IP address for static IP address” and fill the details.
For TCP/IPv4 you can use any IP address within range from 192.168.1.1
to 192.168.1.255 (excluding 192.168.1.203)
g. Fill 255.255.255.0 in Subnet mask
h. Click
“OK”
I. After above steps setting up IP address successfully, please click into web
UI by IP address 192.168.1.203 on IE or Chrome browser