Beagle Installation Instructions
Page 13 of 17
Operational Setup
Step 1: Open the fan and vent caps (Beagle G only).
A.
This step only applies to the Beagle G.
B.
Before turning the antenna ON, always open the fan and vent caps. The type of cap may vary.
C.
Ensure that the antenna is away from any liquids when the caps are open.
Figure 13: Open the fan and vent caps. (Beagle G)
Step 2: Power on the antenna.
A.
For Beagle L,
connect a power cord to the AC outlet on the outside of the case.
B.
For Beagle G,
follow steps 2C-2G below.
C.
Turn the battery pack ON by pressing and holding the power button for 3 seconds. The display on
the battery pack will indicate the battery pack’s curr
ent battery life (%).
Do not hold the button for
longer than 3 seconds; this will cause the battery pack to enter programming mode. To exit
programming mode, turn the battery pack OFF then ON again.
D.
Set the AC output switch on the battery pack to ON. The switch can be accessed through the slot
in the cover plate.
E.
Shortly after turning on the battery pack, the fan will start.
F.
To charge the battery pack, connect the battery pack charger to the DC charging port on the
outside of the case.
G.
See Page 16 for Battery Operation and Safety Guidelines.