EN
1. Install cannons on the front of the wings using
two screws (
A
) for each cannon.
2. Install antenna in slot on top of the fuselage
behind the canopy.
1. Install the tube in the hole in the fuselage.
2. Install the left horizontal tail on tube.
3. Install the left horizontal tail in fuselage mount.
4. Install the right horizontal tail on tube, in mount
and on connector with left tail.
5. Apply four pieces of tape on the fuselage
mounts and top and bottom of the horizontal tail.
6. Attach clevis to the elevator control horn (see
instructions for clevis connection).
7. When needed, disassemble in reverse order.
A
1.5 X 7mm
(4)
Intallation
1. Install the left landing gear plate (
A
) (marked
with an L) in wing using four screws (
B
).
2. Install the left landing gear strut in plate (as
shown).
3. Install the left cover (
C
) (marked L) on strut (
D
)
using two screws (
E
).
4. Install wheel on the strut using collar. Make sure
the bushing side of the wheel is toward the bend
in the strut.
5. Tighten setscrew (
F
) in collar. Use a small
amount of threadlock to hold setscrew in collar.
6. Install the left wheel pant (
G
) (marked L)
on the strut.
7. Install right landing gear the same as left
landing gear.
Removal
When needed, disassemble in reverse order.
2 X 12mm
(4)
3 X 4mm
(2)
3 X 23mm
(8)
B
A
C
D
G
E
F
Installing Landing Gear
Installing Cannons and Antenna
Installing Horizontal Tail
7