EN
Tip:
Turn the clevis on the linkage to change the length of the linkage
between the servo arm and the control horn.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
After binding a transmitter to the model receiver, set the trims and sub-
trims to 0, then adjust the clevises to center the control surfaces.
1.
4.
5.
6.
2.
3.
Fly the model at factory settings before making changes. For pilots who
wish to fl y the model with more control throw, adjust the position of the
linkages on the servo arms and control horns for increased travel.
57mm
2.25 inches back from leading edge
of the top wing.
Install the fl ight battery all the way to the front
of the battery compartment. Make sure the fl ight
battery is secured using hook and loop straps. It is
easiest to balance the Albatros D. Va with the
aircraft upright.
Horns
Arms
Elevator
Ailerons
Rudder
Installing Clevises on Control Horns and Control Centering
Factory Settings
Center of Gravity (CG)
11