Parkside PWSAM 20-Li A1, Translation Of The Original Instructions

Page: 42 / 178

GB
42
Cleaning
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Maintenance
The device is maintenance free.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
Storing cutting/grinding discs
• dry
• upright
• unstacked
Troubleshooting
The following table will assist you in fixing faults:
Problem
Possible cause Error correction
Rechargeable battery (9) not
inserted
Inserting the battery ,
p. 41
On/Off switch (5) is broken contact the service centre.
Rechargeable battery (9) dis-
charged
Charging the battery,
p. 39
Device does not start
Defective motor contact the service centre.
Clamping screw (15) loose Tighten the clamping screw
(15), Attaching and remov-
ing the attachment tool,
p. 38
Attachment tool does not
move although motor is run-
ning
Workpiece, workpiece rem-
nants or remnants of attach-
ment tools blocking the drive
Remove blockages
Reduce pressure on attach-
ment tool
Engine is slowing down and
stops
Device is overloaded through
workpiece
Workpiece unsuitable