17
GB/IE/NI/CY/MT
z
Before use
Take all parts from the packaging and
check whether t
he flux cored wire welder
or parts show any damage. If this is the
case, do not use the flux-core wire wel-
ding device. Contact the manufacturer
via the indicated service address.
Remove all protective films and other
transport packaging.
Check that the delivery is complete.
The welding nozzles can be stowed
away in the storage compartment for
welding nozzles
26
.
z
Assembly
z
Assembling the welding
mask
Place the dark welding glass
21
into the
mask with the writing on the top
20
(see
Fig. C). The writing on the dark welding
glass
21
must now be visible from the
front of the welding mask.
Push the handle
22
from the inside into
the corresponding notch of the mask, un-
til it snaps into place (see Fig. D).
z
Inserting the flux-cored
wire
Always unplug the mains
plug from the mains socket prior to each
maintenance task or preparatory work in
order to prevent the risk of an electric shock,
injury or damage.
Note:
Different welding wires will be nee-
ded depending on the application. Welding
wires with a diameter of 0.6 – 1.0 mm can
be used with this device.
Feed roll, welding nozzle and wire cross
section must be compatible with one another.
The device is suitable for wire reels weighing
up to maximum 1000 g.
Unlock and open the cover of the wire
feed unit
1
by raising the threaded rod
along the elongated hole.
Unlock the roller unit by turning the roller
mount
29
anti-clockwise (see Fig. F).
Pull the roller mount
29
off the shaft (see
Fig. F).
Note:
Make sure that the end of the wire
does not come loose and cause the roll to
roll out on its own. The end of the wire may
not be released until during assembly.
Completely unpack the flux-cored wire
welding reel
17
, so that it can unrolled
without difficulty. Do not release the wire
end yet (see Fig. G).
Place the wire reel on the shaft.
Make sure that the roll unwinds on the
side of the
31
wire feed guide (see Fig.
G).
Place the roll mount
29
back on and lock
it by pressing and turning it clockwise
(see Fig. G).
Undo the adjustment screw
27
and swing
it upwards (see Fig. H).
Turn the thrust roller unit
28
to the side
(see Fig. I).
Loosen the feed roll holder
30
by turning
it anti-clockwise and pull it upwards and
off
(see Fig. J).
On the top of the feed roll
19
, check
whether the appropriate wire thickness
is indicated. If necessary, the feed roll
has to be turned over or replaced. The
supplied welding wire (Ø 0.9 mm) must
be used in the feed roll
19
with the spe-
cified wire thickness of Ø 0.9 mm. The
wire must be positioned in the upper
groove!
Put on the feed roll holder
30
again and
screw clockwise direction.
Remove the torch nozzle
9
by pulling it
and turning it clockwise (see Fig. K).
Unscrew the welding nozzle
15
(see Fig.
K).
Guide the hose package
12
away from
Before use / Assembly
Summary of Contents for PFDS 120 A2
Page 3: ...1 2 4 9 10 11 12 3 5 7 6 8 A B C D 13 15 14 16 17 18 22 23 24 25 19 20 21...
Page 70: ...70 FR BE CH...
Page 156: ...156 SK...
Page 180: ...180 ES...
