Parkside PDSS 310 B5, Original Instructions Manual, Page: 10 / 117

PDSS 310 B5 ■ 6 │
GB
│
CY
■ Keep work area clean and well lit . Cluttered or
dark areas invite accidents .
This gives you better control of the tool in un-
expected situations .
WARNING!
► Have your power tool serviced by qualified
trained personnel using only original spare
parts . This ensures that the safety of the tool is
maintained .
■ Keep children and other persons away from the
tool during operation . Distractions can cause
you to lose control of the tool .
■ Dress properly . Do not wear loose clothing or
jewellery . Keep your hair, clothing and gloves
away from moving parts . Loose clothes, jewel-
lery or long hair can be caught in moving parts .
■ Put the trigger and the tool away in the event of
an unexpected compressor failure .
■ Wherever possible, use a condensate separator
or drain the condensate (water) from the hoses
and tubing regularly before and during the use
of the compressed air tools .
■ CAUTION! An undersized compressed air
system will reduce the efficiency of your tool .
■ Please ensure that you have read and under-
stood the safety instructions regarding multiple
hazards before installation, operation, repair,
service and replacement of any accessories
and before working in the vicinity of the auto-
matic screwdriver . Otherwise, there is a risk of
serious physical injuries .
■ The automatic screwdriver should only be fitted,
adjusted or used by qualified and trained
operators .
■ The automatic screwdriver may not be modified .
Modifications can reduce the effectiveness of
the safety measures and increase the risks for
the operator .
■ Do not lose the safety instructions – hand them
to the operator .
■ Never use a damaged power screwdriver .
■ The machines must be serviced regularly to
check whether the rated values and labels
required in the relevant part of ISO 11148 are
marked on the machine in a legible manner .
The employee/user must contact the manufac-
turer to obtain replacement labels if necessary .
Hazards caused by flying parts
■ If a workpiece or one of the accessory parts or
even the machine tool itself breaks, parts can
be flung out at high speed .
■ Always wear impact-resistant safety goggles
during operation, when replacing accessory
parts or during repair or maintenance work .
The level of the required protection must be
evaluated separately for each individual task .
■ You must ensure that the workpiece has been
securely fixed in place .
■ Check regularly that the rotation speed of the
compressed air tool is not higher than the spec-
ified rotation speed marked on the compressed
air tool . These rotation speed tests must be con-
ducted without any accessory tools attached .
■ Ensure that sparks and fragments created during
work do not constitute a hazard .
■ Disconnect the compressed air tool from the
compressed air supply before replacing an
attachment or accessory, and before adjusting
a setting, servicing the tool or cleaning the tool .
■ Ensure that other people are not put at risk .
Hazards caused by entanglement
■ Hazards caused by entanglement may result
in suffocation, scalping and/or cuts if loose
clothing, personal jewellery, necklaces, hair or
gloves are not kept away from the machine and
its accessories .
■ Gloves can become caught in the rotating drive,
which can lead to injuries or fractures of the
fingers .
■ Rubber or metal-reinforced gloves can easily
become entangled in rotating drive fittings and
extensions .