Parkside PASSK 20-Li B2, Translation Of The Original Instructions, Page: 139 / 216

21
GB
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per
-
son in order to prevent hazards.
• The battery of your device is
only partially pre-charged and
must be properly charged for the
first time before use. Connect the
charger to the mains and insert
the battery in the base.
• Pull the mains plug when the
battery is fully charged and
disconnect the battery from the
charger.
• Do not use the charger to
charge non-rechargeable bat-
teries.
The device could become
damaged.
Charging Process
Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury from
escaping electrolytic solution! After
eye/skin contact, rinse the affected
areas with water or a neutraliser
and consult a doctor.
Charge the battery in a dry
room only. Prior to attaching
the charger, check that the battery‘s
outer surface is clean and dry.
There is a risk of injury due to
electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
The rechargeable battery only reach-
es its full capacity once it has been
charged several times.
• Charge the battery before the first time
of use. Do not briefly recharge the bat
-
tery several times in a row.
• Only charge with the originally sup
-
plied charger.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Online-Shop
(www.grizzlytools.shop).
• Always take heed of the applicable
safety instructions as well as the envi
-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
Battery
Only insert the rechargeable battery
once the battery-operated tool is
ready for use. Risk of injury!
1. To remove the battery (4) from the ap
-
pliance, press the release button (1) on
the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli
-
ance. It will audibly snap in.
Checking the charge status
of the rechargeable battery
The battery charge status indicator (3) sig-
nalises the state of charge of the battery (4).
Press the button (2) on the battery. The
state of charge of the battery is displayed
by illuminating the 3-colour LED lights of
the state of charge display.