Parkside PABS 18-LI B2, Operation And Safety Notes

Page: 7 / 82

7 GB
Introduction
11
Rechargeable battery charge state button
12
LED working light
13
Drill chuck
14
Torque pre-selector
15
fast charger
16
Red charge-control LED
17
Green charge-control LED
Q
Scope of delivery
1 Cordless drill with rechargeable battery pack
1 Bit PH2 50 mm
1 fast charger
1 Carry case
1 Directions for use
Q
Technical Data
PABS 18-Li B2 Cordless drill:
nominal voltage: 18 V
Idle-running speed: 1st gear: max. 400 min
-1
Idle-running speed: 2nd gear: max. 1400 min
-1
Drill chuck
clamping range:
max. 10 mm
Maximum
drill diameter:
Steel: 10 mm,
Wood: 30 mm
Max. torque: 35 nm
PABS 18-Li B2-1 Battery Pack:
Type: LITHIUM-IOn
nominal voltage:
18 V
Capacity: 1.5 Ah
Energy content: 27 Wh
PABS 18-Li B2-3 Fast Charger:
INPUT
nominal voltage: 230 V∼, 50 Hz
nominal output: 55 W
OUTPUT
nominal voltage: 18 V
Charging current 2 A
Charging time: approx. 60 min
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with En 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 76 dB(A)
Sound power level:
87 dB(A)
Uncertainty K: 3 dB
Total vibration (vector sum of three directions) is
calculated in accordance with En 60745:
Drilling in metal: Vibration emission value
a
h,D
= 0.865 m / s
2
,
uncertainty K = 1.5 m / s
2
,
Screwing: Vibration emission value
a
h
= 2.546 m / s 2 ,
uncertainty K = 1.5 m / s 2 .
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in En 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical
power tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
Introduction / General safety advice for electrical power tools