Parkside PAAS 20-Li A1, Translation Of The Original Instructions

Page: 26 / 274

26
GB MT
lulled into a false feeling of se-
curity and do not disregard the
safety rules for power tools,
even if you are familiar with the
power tool after using it many
times.
Careless action can lead to
serious injuries within a fraction of a
second.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application.
The correct power tool
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off.
Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust
-ments, changing accessories, or
storing power tools.
Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool.
Power
tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of mov-
ing parts, breakage of parts and
any other condition that may af-
fect the power tool’s operation.
If
damaged, have the power tool repaired
before use. Many accidents are caused
by poorly maintained power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
etc. in accordance with these
operating instructions. Take into
account the working conditions
and the work to be carried out.
Using the power tool for anything
other than its intended use can lead to
dangerous situations.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease.
Slippery handles and grip
surfaces do not permit safe operation
and control over the power tool in un-
expected situations.
5) USE AND TREATMENT OF THE
BATTERY-POWERED TOOL
a) Only recharge batteries using
chargers recommended by the
manufacturer.
If a charger that has
been designed for a particular type of
battery is used to charge other batter-
ies, there is a risk of fi re.
b) Only use the battery that is
intended in an electric tool.
The
use of other batteries may create a fi re
hazard and lead to injury.
c) When not in use, keep batteries
away from paper clips, coins,
keys, nails, screws or other
small metal objects that could
cause the contacts to be bridged.
A short circuit between battery contacts
can result in burns or a fi re.
d) When misused, fl uid may leak
from the battery. Avoid any
contact with it. On accidental
contact, wash in running water.
If the fl uid comes into contact