13
GB
16. Troubleshooting
Fault
Possible cause
Remedy
Motor does not work
Motor, cable or plug defective, the mains circuit
breaker switched off
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary.
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged, capacitor burnt
Contact an electrician to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a special-
ist.
Motor makes excessive
noise
Coils damaged, motor defective
Arrange for inspection of the motor by a specialist
The motor does not
reach its full power.
Circuits in the network are overloaded (lamps,
other motors, etc.)
Do not use any other equipment or motors on the same
circuit
Motor overheats easily.
Overloading of the motor, insufficient cooling of
the motor
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Saw cut is rough or wavy
Saw blade dull, tooth shape not appropriate for
the material thickness
Re-sharpen saw blade and/or use suitable saw blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or saw blade not
suitable for use
Insert suitable saw blade
Summary of Contents for MPKZ 2000 A1
Page 5: ...17 30 16 28 29 C 12 33 34 18 31 5 6 20 E 19 32 38 E E 14 15 4 4 7 7 14 14 13 24 24a 25...
Page 93: ......
Page 94: ......
