Parkside 374688 2104, Translation Of The Original Instruction

Page: 13 / 60

13
GB IE NI CY
3. Release the retaining screw for the an-
gular adjustment (7) and turn the tool
table (6) into position. Select the angle
according to the existing bevel angle
(angle of the bevelled edge).
4. Tighten the retaining screw for angular
adjustment (7) again.
5. Switch the device on and move the tool
table (6) equally back and forth along
the grinding wheel (10).
6. Always use light pressure while sharp-
ening and slowly push the blade to-
wards the grinding wheel (10).
7. Repeat the sharpening process until all
irregularities have been removed.
8. Switch the device off and wait for the
grinding wheel (10) to stop.
To sharpen a chisel, turn the chisel
over and repeat the process from
Point 5.
Sharpening knives
The device is not suitable for grind-
ing serrated knives.
1. Mount the selected sharpener (see
Mounting sharpener).
2. Turn the machine on.
3. Insert the blade of the knife right into
the grinding slot.
4. Using light pressing guide the blade
along the grinding wheel (10) and
evenly and slowly pull the knife to-
wards you.
5. Turn the knife and insert the knife blade
into the opposite grinding slot.
6. Repeat this grinding process for this
side of the blade as well.
7. Execute the alternating grinding pro-
cess until the cutting edge is burr-free
and sharp.
8. Switch the device off and wait for the
grinding wheel (10) to stop.
Sharpening scissors
The device is not suitable for grind-
ing serrated scissors. The device
is not suitable for grinding pinking
shears.
1. Mount the selected sharpener (2)(see
Mounting sharpener).
2. Completely open the scissors.
3. Turn the machine on.
4. Insert one of the scissor blades into the
grinding slot.
5. Using light pressure guide the blade
from the screw up to the tip along the
grinding wheel (10).
6. Remove the scissors from the sharpen-
ing station and turn the scissors to
sharpen the other blade.
7. Insert the other scissor blade into the
grinding slot.
8. Using light pressure guide the blade
from the screw up to the tip along the
grinding wheel (10).
9. Execute the alternating grinding pro-
cess until the cutting edges are burr-free
and sharp.
10. Switch the device off and wait for the
grinding wheel (10) to stop.