Parker SensoControl Serviceman SCM-150 Series, Operating Instructions Manual

Page: 13 / 39

Using the data output
The SCM-150-1-02 has an infra-red interface to
document actual, maximum and minimum values
in numeric form. The hand meter can be
connected to the thermal printer SCPR-100 via
the cable SCK-700-00-29. If the adapter
SCDA-150 is used, the data is transmitted to a
PC. There are two types of output possible.
1. One-off print-out when "PRINT" key is
pressed
Set as follows:
Press "PRINT" key and switch on SCM-150.
"Pr" is displayed.
Press "RESET" key in order to select PRINT
(Pr) or PC format (PC).
Confirm selection by "HOLD" key.
Set value to 0 using the "MAX/MIN" keys.
Press the "HOLD" key to transfer the values.
2. Permanent output after a previously set
interval
Set as follows:
Press the "PRINT" key and switch on the
SCM-150. "Pr" is displayed.
Press "RESET" key in order to select PRINT
(Pr) or PC format (PC).
Confirm selection by "HOLD" key.
Set print-out interval between 1 - 100 seconds
using the "MAX/MIN" keys.
Press the "HOLD" key to transfer the values.
Start print-out by pressing the "PRINT" key.