Chapter 2: Installing the PowerStation
Installing the XP PowerStation
XP Series PowerStation User Guide
2-8
Figure 2-2: Sliding Mechanism for the 6” PowerStations
3
Slide the feet of the mounting clip into the slot, then slide the clip
over to properly mount the unit.
4
Tighten each of the mounting screws against the front of the
enclosure.
5
Torque them down to
6 in/lbs
.
6
Tighten the screws in a crosswise sequence to ensure a good seal
and prevent damage. Tightening the bracket assembly may not
ensure that the gasket seal is totally depressed by the bezel. You
may see a small gap between the bezel and the enclosure.
Mounting Clamps