CTC Parker Automation
A3-06137-100
R S 9 D R A M I n s t a l l a t i o n
Introduction
These instructions explain how to install or replace DRAM modules in the
PowerStation RS9 or the RSPC9 Industrial PC. They include steps for
disassembling the unit, removing previously installed DRAM module(s),
installing new DRAM, and reassembling the unit.
Warning
For safety reasons, the unit should be opened only by qualified
service personnel.
Warning
Be sure to observe electrostatic discharge (ESD) precautions
while working inside the unit.
To complete this procedure, you will need the following items:
•
The DRAM module(s) that you purchased:
• 32MB SDRAM DIMM (DIM-9032)
• 64MB SDRAM DIMM (DIM-9064
• 128MB SDRAM DIMM (DIM-9128)
• 256MB SDRAM DIMM(DIM-9256)
•
Phillips-head screwdriver
Disassembling the Unit
To disassemble the unit, follow these steps:
1. Turn off the system.
2. Disconnect the unit from the power source.
3. Remove the four screws securing the back cover to the unit, as
shown in Figure 1 on page 2.
Note
Screws 1 and 2 are located at the sides of the cover; screws 3 and 4 are in the
back of the cover.
