PVSG User Guide
VI
Safety
Do not perform the procedures in this manual unless you are experienced in the handling of electronic
equipment.
Contact the manufacturer if there is anything you are not sure about or if you have any questions
regarding the product and its handling or maintenance.
The term “manufacturer” refers to Parker Hannifin Corporation.
Safety symbols
The following symbols are used in this document to indicate potentially hazardous situations:
Danger! Risk of death or injury.
Warning! Risk of damage to equipment or degradation of signal
When you see these symbols, follow the instructions carefully and proceed with caution.
General safety regulations
Work on the hydraulics control electronics may only be carried out by trained personnel who are well-
acquainted with the control system, the machine, and its safety regulations.
Follow the manufacturer’s regulations when mounting, modifying, repairing, and
maintaining equipment. The manufacturer assumes no responsibility for any accidents
caused by incorrectly mounted or incorrectly maintained equipment. The manufacturer
assumes no responsibility for the system being incorrectly applied, or the system being
programmed in a manner that jeopardizes safety.
Do not use the product if electronic modules, cabling, or connectors
are damaged or if the control system shows error functions.
Electronic control systems in an inappropriate installation and in combination with
strong electromagnetic interference fields can, in extreme cases, cause an unintentional
change of speed of the output function.