Parker PAC, Installation Manual, Page: 22 / 197

INSTALLATION
22 Parker Automation Controller Installation Guide
Installation Overview
The illustration below shows the components that you need to install the PAC. It shows the Controller
connected to multiple PACIO Modules. The recommended installation process follows.
Basic Installation Steps
The following steps give a high-level overview of the installation process. See the remainder of the chapter
for additional details on completing each step.
1.
Verify the shipment is correct.
2.
Mount the PAC Controller on a DIN rail in a suitable tool-accessed fire enclosure.
3.
Remove the protective rubber E-Bus cover from the right side of the Controller.
4.
Connect the desired PACIO Modules to the right side of the controller.
5.
Connect all input and output field wiring to the PACIO Modules.
6.
Connect an Ethernet communication cable between the Controller and a network, laptop
computer or PC.
7.
Connect 24VDC power to the Controller and PACIO Modules.
8.
Use the PAC Configuration Tool to configure the PAC system settings, such as Machine Name, IP
addresses, and system date and time.