5
HANDLE ASSEMBLY
Install handle assembly to blower, place rubber shim (1)
under handle strut (2) and place 5/16-18 x 2 bolt (4) and 3/
8 washer (3) into holes in handle strut (2) and through frame
(5) and tighten (not all the way) with 5/16 washer (6) and 5/
16-18 nyloc nut (7). Place handle (8) into handle struts (2)
and align holes in handle (8) and struts (2). Place 5/16-18 x
2 bolt (4) and 3/8 washer (3) into strut (2) and handle (8), as
shown, and tighten with 3/8 washer (3) and 5/16-18 nyloc
nut (7). Thighten bolts on strut/frame at this time.
THROTTLE CABLE ASSEMBLY
From operator postion, the throttle cable can be installed
on outside of handle on right side or on inside of handle on
left side. To install throttle cable (1) to handle (5), place
1/4” bolt (2) through center hole in cable (1) Place bolt
through handle (5).add nut (4) and tighten. Mount snap mount
(6) and cable to handle (5). Place and thighten cable tie (7)
and cable around handle strut (8).
ASSEMBLY INSTRUCTIONS
FRONT WHEEL ASSEMBLY
Install front wheel bracket (1) to front housing using 5/16 flat
washers (2) and 5/16 nyloc nuts (3) and tighten. Install front
wheel (4) into front wheel bracket (1). Slide nylon washer
(6) onto sholder bolt (7) and slide sholder bolt(7) all the way
through front wheel bracket (1) and front wheel (4). Place
third 1/2 flat washer (6) onto sholder bolt(7) and secure with
nut(8).
