Parker HLR Series, Mounting Instructions

Page: 41 / 56

Parker EME Lubrication of the guiding system
192-510201N1 HLR 2019-04
41
5.3 Lubrication of the guiding system
Before working with lubricants please read the respective supplier manuals and
adhere to it.
Improper or insufficient lubrication or wrong lubricant can cause irreparable
damage to the linear actuator guidance system and result in e.g. higher wear,
reduced precision, higher friction and higher noise level. Furthermore, the
expected lifetime may reduce significantly.
Linear actuators are lubricated before shipment. In the case of storage or
downtimes of more than 1 year, the guiding system of the linear axis must be
lubricated before initial operation. For low mileages, the linear axis guide must be
lubricated at least once a year, even if the lubrication interval has not been
reached.
Grease gun
To relubricate the guiding system, use a grease gun suitable for the grease
nipples. We recommend a one-hand lubrication press (optionally available, article
number see HLR catalogue) with nozzle attachment type D1a4 (DIN3405).
Lubrication intervals
Minimum lubrication intervals for grease are influenced by different parameters
(time, load ratios, operating loads). Minimum lubrication intervals can be seen in
the following diagram.
Figure 11: Lubrication intervals of the guiding system
1 Lubrication interval [km]
2 Load comparison factor fv*
* Calculation of the load comparison factor please refer to the HLR catalogue.
Lubricant and amount of lubricant
HLR070 / HLR080
Recommended lubricant
-
Klüberplex BEM34-132
Lubricating amount depending on
lubricating nozzle
[g]
1.2
Lubricating amount per carriage / Linear
actuator
[g]
2.4
Table 12: Lubricant and amount of lubricant