Parker H Series, Installation & Service Instructions Manual

Page: 338 / 344

Installation & Service Instructions
V345P
25-Pin, D-Sub Cable
ISSUED: August, 2004
Supersedes: June, 2003
Doc.# V-345P, ECN# 040841, Rev. 2
Pneumatic Division
Richland, Michigan 49083
!
!
WARNING
To avoid unpredictable system behavior that can cause personal injury
and property damage:
• Disconnect electrical supply (when necessary) before installation,
servicing, or conversion.
• Disconnect air supply and depressurize all air lines connected to
this product before installation, servicing, or conversion.
• Operate within the manufacturer’s specified pressure, temperature,
and other conditions listed in these instructions.
• Medium must be moisture-free if ambient temperature is below
freezing.
• Service according to procedures listed in these instructions.
• Installation, service, and conversion of these products must be
performed by knowledgeable personnel who understand how
pneumatic products are to be applied.
• After installation, servicing, or conversion, air and electrical
supplies (when necessary) should be connected and the product
tested for proper function and leakage. If audible leakage is present,
or the product does not operate properly, do not put into use.
• Warnings and specifications on the product should not be covered
by paint, etc. If masking is not possible, contact your local
representative for replacement labels.
WARNING
FAILURE OR IMPROPER SELECTION OR IMPROPER USE OF
THE PRODUCTS AND/OR SYSTEMS DESCRIBED HEREIN OR
RELATED ITEMS CAN CAUSE DEATH, PERSONAL INJURY AND
PROPERTY DAMAGE.
This document and other information from Parker Hannifin Corporation,
its subsidiaries and authorized distributors provide product and/or
system options for further investigation by users having technical
expertise. It is important that you analyze all aspects of your application,
including consequences of any failure and review the information
concerning the product or systems in the current product catalog. Due
to the variety of operating conditions and applications for these products
or systems, the user, through its own analysis and testing, is solely
responsible for making the final selection of the products and systems
and assuring that all performance, safety and warning requirements
of the application are met.
The products described herein, including without limitation, product
features, specifications, designs, availability and pricing, are subject
to change by Parker Hannifin Corporation and its subsidiaries at any
time without notice.
EXTRA COPIES OF THESE INSTRUCTIONS ARE AVAILABLE FOR
INCLUSION IN EQUIPMENT / MAINTENANCE MANUALS THAT UTILIZE
THESE PRODUCTS. CONTACT YOUR LOCAL REPRESENTATIVE.
25-Pin, D-Sub Cable
25-Pin, D-Sub Cable Specifications
Common Pin “13” is rated for 3 amps. Common wire rating
must be greater than total amperage of all solenoids on a
Add-A-Fold assembly.
Example: 12 station manifold, 24 solenoids,
24VDC — For 24 x .095 amps = 2.28 total amp rating which
is less than three amps.
25-Pin, D-Sub Cable (Female)
1
2
3
4
5
6
7
8
9
10
11
12
13
Black
Brown
Red
Orange
Yellow
Green
Blue
Purple
Gray
White
Pink
Lt Green
Black / White
14
15
16
17
18
19
20
21
22
23
24
25
Color
Brown / White
Red / White
Orange / White
Green / White
Blue / White
Purple / White
Red / Black
Orange / Black
Yellow / Black
Green / Black
Gray / Black
Pink / Black
Color
Pin
Number
Pin
Number
1
3
5
7
9
11
13
15
17
19
21
23
Common
2
4
6
8
10
12
14
16
18
20
22
24
Address Address
Introduction
Follow these instructions when installing, operating, or
servicing the product.