Compax3 device description
Motor / Motor
brake (plug X3)
24
I11 T11 192-120101 N6 - March 2004
Connection of the power voltage of 2 Compax3 V4 devices (400V
devices)
In order to improve the conditions during brake operation, the DC power voltage of
2 devices may be connected.
The capacity as well as the storable energy are increased; furthermore the braking
energy of one device may be utilized by a second device, depending on the
application.
Please connect as follows:
Device 1 X2/4 to device 2 X2/4
Device 1 X2/5 to device 2 X2/5
Please note the following:
Caution! In case of non-compliance with the following instructions, the
device may be destroyed!
!
You can only connect two similar devices (same power supply; same rated
currents)
!
Connected devices must always be fed separately via the AC power supply.
3.1.6.
Motor / Motor brake (plug X3)
PIN
Description
1
U (motor)
2
V (motor)
3
W (motor)
4
PE (motor)
5
BR+
Motor holding brake
6
BR-
Motor holding brake
Screening connection of the motor cable
The motor cable should be fully screened and connected to the Compax3 housing.
We offer a special
shield connecting terminal
as accessory item (see on page
134).
Connect the brake only on motors which have a holding
brake! Otherwise make no brake connections at all.
Motor holding brake output
Controller type
Compax3
Voltage range
21 – 27VDC
Maximum output current (short circuit
proof)
1.6 A
Motor cable
(see on page 121)