EN - 7
Fuel is highly flammable and its vapors can
explode. ONLY use approved fuel containers.
•
NO Smoking!
•
NO Sparks!
•
NO Flames!
•
Allow engine to cool before filling fuel
tank.
Never fill containers inside a vehicle or on a
truck or trailer bed with a plastic liner. Always
place containers on the ground away from
your vehicle before filling.
When practical, remove gas-powered
equipment from the truck or trailer and refuel
it on the ground. If this is not possible, then
refuel such equipment on a trailer with a
portable container, rather than from a
gasoline dispenser nozzle.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle lock-
open device.
Use only an approved gasoline container with
an appropriately sized dispensing spout.
Check fuel supply before starting engine.
DO NOT fill gasoline tank indoors, when
engine is running, or while engine is hot.
Allow engine to cool several minutes before
removing fuel cap.
Do not mix oil with gasoline.
DO NOT overfill. Allow about 1/2” (12 mm) of
tank space for fuel expansion.
Replace gasoline tank cap securely and
clean any spilled fuel before starting engine.
If fuel is spilled on clothing, change clothing
immediately.
Properly remove fuel before tipping unit.
NEVER store fuel inside where there is an
open flame, such as a water heater.
ALWAYS drain fuel outdoors away from
ignition sources.
Never pick up or carry equipment while the
engine is running.
ALWAYS shut off engine and close fuel
shutoff valve when transporting unit on a
truck or trailer.
Use at least two people when loading or
unloading machine.
DO NOT drop machine when loading or
unloading or damage to rear axle may occur.
The blower covered in this owner's guide is
shipped complete in one box. Follow all
instructions on assembly very carefully.
Carton Contents
Unit
Literature Pack
ASSEMBLY
1. Remove all items from carton.
2. Position blower on its wheels and chock
wheels to keep unit stable.
NOTE:
DO NOT discard the carton or any of
the inserts until the unit is completely
assembled.
3. Remove four 5/16" hex bolts (item 4),
four 5/16" locking hex nuts (item 2) and
handlebar brackets (item 5) that are
loosely assembled on the handlebar
supports.
Handle Assembly
1. Mount handlebar (item 1) to the
handlebar supports (item 3) using four
5/16" hex bolts, four 5/16" locking hex
nuts and two handlebar brackets.
2. Torque fasteners to 17 lbf-ft (1.9 N•m).
Do not overtighten.
ASSEMBLY
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.