Humidity Setting
• Tap the Humidity Button to set the humidity level from 40% to 80% in 5% increments, the set
humidity level will flash three times to confirm your setting.
• When the preset humidity level is reached, the unit will stop misting.
• To cancel Humidity setting, tap and hold the Humidity Button for 2 seconds or repeatedly tap the
Humidity Button until “--” is displayed.
The most comfortable environmental humidity is between 40%-60%. Please adjust the mist as
needed.
Warm Mist Adjustment
• Tap the Warm Mist Button to cycle through High (level 3) -> Medium (level 2) -> Low (level 1) heat
levels -> OFF. The corresponding heat level will light up on the LED Display.
• The set heat level will flash three times to confirm your setting.
AUTO Mode
• Tap the AUTO button to activate the automatic humidifying mode.
• Under AUTO mode, the mist level and heat level are automatically adjusted based on the environ-
mental humidity to the most comfortable level (55%~65%).
• Once 65% humidity is reached, the humidifier will shut off automatically. When the environmental
humidity is below 60%, the unit will restart working again.
• When AUTO mode is activated, changing the mist level or heat level will cancel the AUTO mode.
Sleep Mode
• Tap and hold the AUTO Button on the control panel for 2 seconds or directly press the Sleep Button
on the remote control to turn off the LED display with a beep.
• To turn the display back on, tap any button on the control panel to wake it up. If no operation is
done within 3 seconds, the LED display will turn off automatically.
12
11
• When Low Water Protection is activated under sleep mode, the LED display will flash 3 times
without beeps. Tap and hold the AUTO Button for 2 seconds again to turn off the LED display with a
beep.
Timer Setting
• Tap the Timer Button to set the timer from 1 to 9 hours by 1 hour increments, the timer will flash
three times to confirm your setting. When time is up, the unit will automatically turn off.
• To cancel Timer setting,
1. Keep tapping the Timer button until “0H” displayed or
2. Tap and hold the Timer Button for 2 seconds.
Low Water Protection
• When there is not enough water inside the water reservoir, the humidifier will stop misting and Low
Water Protection will be activated. The LED display will flash 3 times with 3 beeps. It is designed for
safety to prevent the humidifier from possibly overheating and damaging the atomizer.
• The humidifier cannot be started under low water status.
Memory Function
If power is not disconnected, the humidifier will always remember your last settings (except timer
setting) once you turn it on again.