5
TO COMPLETE INSTALLATION YOU WILL NEED THE
FOL LOWING ITEMS (NOT INCLUDED)
SELECTING LOCATION & MOUNTING UNIT
(1) Six (6) feet ½" non-metallic conduit outdoor rated.
(1) ½" conduit compression fitting.
1. Select a location on a wall near the pool equipment or insert posts into the ground,
which will be used to hang unit. The Clear O3
®
unit should be at least one (1) foot
above maximum water level, and for extra safety the unit should be mounted higher
than the filter. The unit should be within five (5) feet of an electrical source, and
within nine (9) feet of plumbing connection. A solid surface is necessary to mount
unit. Mounting brackets are horizontally adjustable to line up with hard points on
the mounting surface. The unit must be mounted horizontally and level on the wall.
Electrical connections should be facing downward.
2. Use provided screws and plastic wall inserts or poles and pole mount clamps
(not included) depending on installation surface available.
3. Four (4) mounting brackets are included (two for the top slot and two for the
bottom slot.
4. Install anchors and screws in desired location for the top hangers. They must be no
further apart than twelve (12) inches. Do not tighten screws all the way. (Fig. 1)
5. Hang the Clear O3
®
from the two top brackets by sliding the keyhole slots over
the screws.
6. Mark the location for the two bottom brackets. (Fig. 2)
7. Remove the Clear O3® from the wall and install the wall anchors.
8. Place the Clear O3® unit back on the screws and line up the two lower brackets
with the wall anchors. (Fig. 3)
9. Install the bottom two screws and
tighten all screws.
Fig. 2
Fig. 3
12" Maximum
Fig. 1