background image

User's Instructionsl

SECTION ONE

Consumer Protection Information

As manufacturers and suppliers of heating products, we take every care, as far as is reasonably
practicable, that these products are so designed and constructed as to meet the general safety
requirement when properly used and installed. To this end, our products are thoroughly tested
and examined before despatch.

IMPORTANT NOTICE: Any alteration that is not approved by the appliance manufacturer
could invalidate the approval of the appliance, operation of the warranty and could affect your
statutory rights.

Health and Safety Notice

Important
This appliance could contain some of the materials, indicated below, that could be interpreted
as being injurious to health and safety. It is the users / installers responsibility to ensure that the
necessary personal protective clothing is worn when handling these materials, see below for
information.

Artificial Fuels, Mineral Wool, Insulation Material, Refractory/Ceramic Fibres, Glass Yam -

may be harmful

if

inhaled, may be irritating to skin, eyes, nose and throat.

When handling

avoid inhaling and contact with skin or eyes. Use disposable gloves, facemasks and

eye protection. After handling wash hands and other exposed parts. If a vacuum is used for cleaning the
coals or cleaning after servicing / installation it is recommended that it be of the type fitted with a HEP A

filter.

Disposal of refractory/ceramic materials.

To keep dust to a minimum

these materials should

be securely wrapped in polythene and be clearly labelled 'RCF waste'

.

These materials are not classified as

'hazardous waste and should be disposed of at a site licensed for the disposal of industrial waste.

The PARAGON TURBO PLUS LPG is a fan flued decorative fuel-effect gas fire, which does

not require a chimney but must be installed on a suitable outside wall

.

It is important that the fan outlet, protected by the terminal guard, is kept clear at all

times.

The PARAGON

TURBO

PLUS LPG is designed

and tested to the requirements

of the

European Standard EN 509.

The appliance

is for use on Propane Gas only and requires a 220-240V

50Hz electrical

supply protected by 3A fuse. It should only be installed by a competent person Le. CORGI-

registered,

in

accordance

with

the

GAS

SAFETY

(INSTALLATION

AND

USE)

REGULATIONS

and I

.

E

.

E

.

WIRING REGULATIONS.

Like all appliances

incorporating

an aerated

burner

with a fanned

flue system

a low

frequency noise may be heard.

It is advised that the PARAGON TURBO PLUS LPG fanned flued fire is serviced annually as
it is more likely to provide trouble-free operation.

The flue be regularly checked and kept clear of any obstruction.

579

22

Summary of Contents for TURBO PLUS LPG







Reviews: