Paragon P10, Instruction For User, Installation & Servicing

Page: 6 / 48

P a g e | 5
LT8540
P10 USERS INSTRUCTIONS
To light the appliance using the remote handset:
A. Point the remote control handset in the direction
of the appliance and simultaneously press the
buttons marked ‘ off’ and ‘standby’. Continue
to hold in these two buttons until a ‘bleep’ is heard
(approximately 2-3 sec.) and then release these
buttons. The appliance will automatically go
through the ignition sequence and the pilot should
ignite. Once the pilot is alight the appliance will
automatically go to the high setting
(approximately 20-25sec). If the ignitor stops
sparking and the pilot fails to light, repeat this
procedure.
B.
The appliance can be adjusted up or down by
pressing the appropriate button
' '
(low setting) or
‘
'
(high setting).There are 5 heat settings and the fire will give a double bleep when the maximum or
minimum heat setting is reached. To switch off the appliance press the OFF
' '
button or if the appliance
is to be switch off for a short period it is recommended that the ‘standby’ button be used.
C. The appliance can be switched off without using the handset by unplugging the transformer. When the
transformer is removed there will be a delay (up to 3minutes) after which double bleeps may be heard
and shortly after the appliance will extinguish. Ensure that the transformer is reconnected once the fire
has been extinguished. The appliance cannot be operated without the use of the handset. If the fire fails
to light or extinguishes for any reason, it will be necessary to re-set the fire. This can be done by pressing
the off
button then following the normal lighting procedure.
NOTE: If the fire is extinguished for any reason wait 3 minutes before relighting.