5
1.
Place the Lower Mast Assembly face down on the floor as shown.
2.
Attach the Wheel Leg Assembly to the Lower Mast Assembly with the
warning decal facing the top of the mast section. Insert the tapered tabs into the slots as
shown.
3.
Secure the Wheel Leg Assembly to the Lower Mast Assembly with two 3” x 3/8” Bolts
and 3/8” Nylock nuts. Tighten with two 9/16” wrenches, or adjustable wrench.
4.
Stand the assembled Lower Mast and Wheel Leg upright.
5.
Align the channels on the back of the Square Cradle to the guide plates on the Lower Mast
as shown, with the support hooks at the bottom and facing away from you. Carefully lower
the Square Cradle to the floor.
6.
Align the Upper Mast Assembly with the Lower Mast Assembly so the two bolt holes line
up.
6a. This is a PINCH POINT. KEEP HANDS AWAY FROM THE JOINT WHERE THE UPPER
AND LOWER MASTS MEET.
7.
Insert both 3” x 3/8” bolts and Nylock nuts.
FAILURE TO INSERT BOTH BOLTS COULD
RESULT IN THE UPPER MAST PIVOTING RAPIDLY DOWNWARD, POTENTIALLY
CAUSING PROPERTY DAMAGE OR SERIOUS INJURY.
ASSEMBLY
1
2
3
4
5
6
6a
7
