Paradyne COMSPHERE 3920PLUS Series, Technical Reference Manual

Page: 247 / 356

COMSPHERE 392xPlus Modems
14-14 October 1998 3920-A2-GH30-40
Table 14-2
(9 of 10)
392xPlus AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
\Nn Asynchronous Error Control Mode.
\N0 Buffer Mode.
\N1 Direct Mode.
\N2 MNP or Disconnect.
\N3 MNP or Buffer.
\N4 V.42/MNP or Disconnect.
\N5 V.42/MNP or Buffer.
\N6 LAPM or Disconnect.
\N7 LAPM or Buffer.
Configure\Edit\
V42/MNP/Buffer
\Qn Asynchronous Flow Control of DTE, Asynchronous Flow Control of Modem.
Flow Control Flow Control
of DTE: of Modem:
\Q0 Disable Disable
\Q1 XON/XOFF XON/XOFF
\Q2 CTS to DTE Disable
\Q3 CTS to DTE RTS to Mdm
\Q4 XON/XOFF Disable
\Q5 Disable XON/XOFF
\Q6 Disable RTS to Mdm
Configure\Edit\
V42/MNP/Buffer
\Tn No Data Disconnect Timer.
\T0 Disable.
\Tn Where n is a value from 1 to 255 in 1-minute increments.
Configure\Edit\
Line Dialer
NOTE: The factory default value is country dependent.
\Xn XON/XOFF Passthrough Flow Control.
\X0 Disable.
\X1 Enable.
Configure\Edit\
V42/MNP/Buffer
%An Error Control Fallback Character.
%An Where n is an ASCII value from 0 to 127. Factory default is 013
ASCII.
Configure\Edit\
V42/MNP/Buffer
%Cn MNP5 Data Compression.
%C0 Disable.
%C1 Enable.
Configure\Edit\
V42/MNP/Buffer
I
Hn V.42bis Compression.
I
H0 Disable.
I
H1 Enable (Transmit (TX) only).
I
H2 Enable (Receive (RX) only).
I
H3 Enable (Transmit (TX) and Receive (RX)).
Configure\Edit\
V42/MNP/Buffer
#DMn SDC Delay Minimization.
#DM0 No delay minimization. The modem does not begin transmitting a
frame to its DTE until the entire frame is received.
#DM1 Delay minimization. The modem transmits data from a DTE frame
to its DTE even if the end of the DTE frame is not yet received
by the modem.
Configure\Edit\
V42\MNP\Buffer