Magellan & Spectra SP • Installation Guide
| 9
Trouble Display
Your alarm system continuously monitors several trouble conditions that can be reported directly to your monitoring station. When a trouble condition occurs, the
[
TBL
]
key will illuminate. Press
the
[
TBL
]
key, and the keypad will illuminate a number corresponding to the trouble the system is experiencing. Except for the Timer
Loss trouble, contact your monitoring station or installer to resolve the trouble condition.
NOTE:
If the keypad emits a
BEEP
every 5 seconds whenever a new trouble condition has occurred, press the
[
TBL
]
key to stop the “Trouble Beep”.
Accessing the Trouble Display
Press [
TBL
]
Key / LED Lit
Trouble Type
Trouble Details
[1]
Wireless Zone Low Battery
The batteries for one of the system’s wireless devices needs to be replaced.
[2]
Power Trouble
The control panel is experiencing power trouble.
[3]
Bell Trouble
There is a bell disconnect/overload on the control panel.
[4] Communication
Trouble
Your alarm system, if monitored, could not communicate with the monitoring
station.
[5]
Tamper/Zone Wiring Failure
A wiring problem is occurring on one or more devices.
[6]
Module Tamper Trouble
A device’s anti-tamper switch has been triggered.
[7]
Fire Loop Trouble
One of the zones is in fire loop trouble.
[8] Timer
Loss
Your alarm system’s clock must be reprogrammed. See
Setting the Time and
Date
on page 7 to set your system’s time and date.
[9]
Wireless Zone Supervision Loss
One or more wireless zones are no longer communicating with the system.
[0 (10)]
Module Supervision Loss
One or more modules are no longer communicating with the system.
[16] / [
SLEEP
]
Keypad Fault
There is a problem with one of your system’s keypads
