Magellan & Spectra SP • Installation Guide
| 25
Advanced System Features
Programmable Outputs (PGMs)
Your system may include one or more PGMs. When a specific event or condition occurs in the system, The PGM can be used to reset smoke detectors, activate light
switches in your home or office, open/close garage doors and much more. If programmed by your installer, you can press and hold keys
[1]
&
[2]
,
[2]
&
[3]
,
[4]
&
[5]
,
[5]
&
[6]
,
[7]
& [
8]
, or
[8]
&
[9]
for each respective PGM. Press and hold
[
CLEAR
]
+
[
ENTER
]
or
[
]
for three seconds to perform a smoke reset. These features must be
set by your installer.
Partitioning
Your system is equipped with a partitioning feature that can divide your alarm system into two distinct areas identified as Partition 1 and Partition 2. When
partitioned, each zone, each user code and many of your system's features can be assigned to either Partition 1, Partition 2, or both partitions.
NOTE
: If the system is not partitioned, all zones, user codes, and features will be recognized as belonging to Partition 1. Partitioning is not available when using a K636
keypad.
Quick Function Keys
Upon request of your installer or monitoring station you may have to perform one of the following. To enter Menu Programming, press
[
]
and then enter your
[
MASTER
CODE
]
. In Menu programming, press:
Test Report
[
MEM
]
+
[2]
If your system is monitored by a monitoring station, this feature will send a test report code to the monitoring station.
Call PC
[
MEM
]
+
[1]
Will initiate a call to the monitoring station that is using the BabyWare software.
Answer PC
[
MEM
]
+
[1]
Will force your security system to answer a call made by your monitoring station that is using the BabyWare software.
Cancel Communication
[
MEM
]
+
[9]
Cancels all communication with the BabyWare software if it has been initiated.
