Paradox Esprit E55, Programming Manual

Page: 15 / 48

Esprit E55 / E65 13
Communication Programming
[800] Dialer Options
Option OFF ON
[1]+2]*
N
See Table
N
See Table
[3]*
Switch to pulse on 5
th
attempt
‡
Disabled
N
Enabled
[4]
Alternate dial
‡
Disabled
N
Enabled
[5]*
Force dial (must be enabled to comply with TBR-21)
N
Disabled
‡
Enabled
[6]*
DTMF dialing
N
Disabled
‡
Enabled
[7]* Pulse ratio
N
1:2
‡
1:1.5
[8]
Reporting
‡
Dialer activated
N
Dialer deactivated
* E55 only
[801] Dialer Options
Option OFF ON
[1] Report system disarming
N
Always
‡
After alarm
[2] Report zone restore
‡
Bell cutoff
N
Zone closure
[3]+[4]
[5] Contact ID Override
N
Disabled
N
CID defaults / slow
format custom
[802] Event Call Direction Options 1
Option OFF ON
[1] Call tel. #1 for arm/disarm report codes
N
Disabled
‡
Enabled
[2] Call tel. #2 for arm/disarm report codes
N
Disabled
‡
Enabled
[3] Call pager for arm/disarm report codes
‡
Disabled
N
Enabled
[5] Call tel. #1 for alarm/restore report codes
N
Disabled
‡
Enabled
[6] Call tel. #2 for alarm/restore report codes
N
Disabled
‡
Enabled
[7]
Call pager for alarm/restore report codes
N
Disabled
‡
Enabled
Telephone Line Monitoring (TLM) Options
[1] [2]
OFF OFF
Disabled
OFF ON
When disarmed: Trouble only
When armed: Trouble only
ON OFF
When disarmed: Trouble only
When armed: Audible alarm
ON ON
Silent alarms become Audible alarm
Auto-Test Report Transmission Options
[3] [4] Auto-Test Report Transmission Options
OFF OFF Transmit the test report code every time the days programmed in section [840] have elapsed at the time programmed in
section [850] (default).
OFF ON When disarmed: Transmit test report code every time the time programmed in section [852] has elapsed. When armed:
Transmit test report code every time the time programmed in section [851] has elapsed.
ON OFF The control panel will transmit the test report code every hour on the minute value programmed in section [850] (the last
two digits). Note that the first two digits of section [850] will be ignored. E.g. If 10:25 was programmed into section [850],
the test report code would be transmitted at the 25th minute of every hour, i.e. 11:25, 12:25, etc.
ON ON The test report code will be transmitted when any of the conditions of the second and third options listed above (options
[3] = OFF and [4] = ON / options [3] = ON and [4] = OFF) are met.