Page 22 of 27
Issued: 2022-08-12
Rev. 2
Your Paradise Hydraulic Boatlift comes with a remote
controller which is shown to the right. The operation of
the remote controller is described below:
Start Button:
Starts the lift session, this must be pressed
prior to actuating the lift, after the stop button is pressed
or after 5 mins has elapsed since the controller was used.
Stop Button
: Ends the lifting session. The up and down
buttons are disabled when this is pressed.
Up Arrow
: Actuates the lift upwards.
Down Arrow
: Actuates the lift downwards.
Light
: Actuates the light kit if optioned. This button is
latching (light remains on when actuated on or off )
If your remote is not working, please check that the 2x
AAA batteries are not dead.
Inside the power pack box, the lift also contains a
hard wired controller, the operation of the controller
is described below:
Enable Button
: Enable button must be pressed and
held to actuate the lift or lights.
Up Arrow
: Actuates the lift upwards when the
enable button is held.
Down Arrow
: Actuates the lift downwards when the
enable button is held.
Light
: Actuates the light kit if optioned when the
enable button is held. This button is latching (light
remains on when actuated on or off ).
REMOTE CONTROL AND CONTROLLER
Pairing the remote:
1. As soon as the controller is powered, the yellow LED of the device starts to flash slowly.
2. Within 15 seconds:
• press START on the handheld to normally activate the device
• then keep any three keys of the handheld pressed down simutaneously (excluding the
STOP) until the yellow LED on the handheld flashes three times.
3. After the triple flash, the handheld/controller system is paired and will remain valid until
a new pairing is performed.
