Card Reader Installation
ACS-1E and ACS-1EUL Installation
ACS-1E and ACS-1EUL Install and Service Manual
Ver 2
17
7. Insert the power supply’s negative lead into the corresponding negative cavity of the ACS-1E con-
troller’s power supply terminal block and fasten the corresponding terminal block’s screw.
8. Turn on the ACS-1E switch and continue with additional installation procedures.
Note:
The power supply for the ACS-1E is 9V.
WARNING: THE MMR POWER BOOSTER IS ONLY USED IN THE ACS-1E CONTROLLER AND SHOULD NEVER
BE INSTALLED IN AN ACS-1EUL CONTROLLER.
3.2.3 IMSR, MMR and MMR-BT Install Diagrams
The drawings on the next 2 pages contain basic installation examples to assist with proper placement
of the ISMR, MMR and MMR-BT Card Readers.
