BA_PH_UT300_EN_18-21.docx
26
The name of the program and all relevant parameters can be entered in the now appearing mask:
Figure 24: Program settings for tool
The "
Program No.
" is assigned automatically (in ascending order). The "
Tool Type
" is not editable be-
cause it has already been selected before. Now use the corresponding fields and enter a unique
name in the "
Name
" field as well as the desired values into the parameter fields
Speed
,
Angle
,
Height
,
Fence
and - if required -
Partial F.
(for the partial fence). If all entries were made, these must
be confirmed with "
Enter
".
Then use the select field "
Datum
" to define either the upper edge, the tool center or the lower edge
as reference point. By using the selection field "
Feed
" you can select the ideal feed rate from the list
as an additional note and save it.
Figure 25: Program creation: Assign feed rate
Depending on the selection of
Top
,
Center
or
Bottom
the supplementary graphic in the right half of
the screen shows exactly where the
reference point
is on the tool. If all entries are correct, press
to save the program.
After saving, the screen changes to the program list, where the newly created program is listed
(see next page).
