BA_PH_680-200_EN_11-22.docx
43
11.2
Switching ON
•
Turn the main switch (right on the control cabinet) to position “
I
”.
•
Press the push-button "Switch on main saw" (
6
) and wait until full speed is reached.
•
Start cutting operation.
11.3
Switching OFF
•
To switch off, press push-button (
4
)
→
The machine is slowed down.
•
Turn the main switch (right on the control cabinet) to position “
0
”
.
11.4
Safety Equipment
The machine is equipped with the following safety systems:
11.4.1
Saw Blade Guard with Extraction
The swivelling guard has a lowerable protective hood with interchangeable insert (for wide and narrow) and a
suction port. The guard thus ensures both effective extraction of chips and sawdust and an effective saw blade
protection.
11.4.2
Safety Switches
The sawdust flap is equipped with a safety switch. This has the effect that the power supply to the main motor
is switched off when the sawdust flap is opened. The same applies to the slide table. This has a safety switch
that switches off the power supply to the main motor as soon as the slide table is above the centre of the ma-
chine. Furthermore, the maintenance cover at the rear of the machine is equipped with a safety switch.
11.4.3
Emergency Stop Switches
The sliding table saw is equipped with two emergency stop switches (one each on the control panel and on the
right of the workpiece feed side on the control cabinet).
The emergency stop switches must always be freely accessible and must not be obstructed by wood or other
objects.
The function of the two emergency stop switches must be checked daily before starting work.
Restart after emergency stop:
1.
Check that there is no longer any danger (determine the reason for triggering the emergency stop)
and that there are no persons in a danger zone.
2.
Unlock the emergency stop switch.
3.
Restart the machine.
11.4.4
Pinch protection bar for the rip fence
The electric motor-driven adjustable rip fence is equipped with a safety device in the form of a pinch protection
bar. This prevents people and objects from being crushed or jammed between the fence and the slide table by
abruptly switching off the positioning.
In order to permanently guarantee the safety function, the pinch protection bar must be re-
placed immediately if it is damaged.
