BA_PH_680-100_EN_08-22.docx
60
15.10
Laser Cut-Position Indicator
As an additional positioning aid for the workpiece, the
sliding table saw can be equipped with a laser cut-position
indicator (Art. No. 4322).
This is particularly useful for visually indicating the kerf on
tear-off or trim cuts, e.g. for board material with a forest
edge.
The laser is mounted on the guard of the machine (see
figure on the right) and is activated by means of a switch
on the control panel.
The laser class is 2.
Figure 81: Laser cut-position indicator
15.11
Trimming with Laser Beam
To trim the workpiece as loss-free as possible, simply push it to the right until the edge to be trimmed is com-
pletely behind the laser beam. Then release the cut.
Figure 82: Trimming with laser beam
15.12
Special Requirements for Use
The laser device must be adjusted in such a way that it is not possible to look directly into the laser beam. t
should also be noted that the laser beam can be reflected from reflective surfaces (e.g. the machine table or
other blank parts).
Warning: Looking directly into the laser beam causes serious eye injuries!
The operating instructions of the laser manufacturer must be observed.
Laser beam
Workpiece
Trimming
Laser device