BA_PH_335-20_EN_07-22.docx
43
14.3
Tighten / Replace the V-Belt
Switch off the machine during maintenance and repair work and secure it against being
switched on again unexpectedly! Lock the main switch with a padlock!!
•
Turn off the main switch (
H
) and lock it.
•
Then remove the belt drive cover on the rear of the machine.
•
Move the main fence completely to the front.
•
Loosen the nuts (
M
) on the angle plate (
W
) and press the motor
block down. A lever made from a piece of wood is very suitable
for this purpose. Then tighten the nuts (
M
) again.
•
Do not tighten the V-belt (
R
) too much. It is correctly tensioned
when it can be pressed through between the V-belt pulleys by
about 1 cm with a lateral force of approx. 2 kg.
•
Remount the rear cover.
Figure 44: Tighten the V-belt
To replace the V-belt, loosen the screws and lift the motor. Then pull the worn belt off the pulleys and fit the
new one. To tension, proceed as described above.
M
W
R
