TERMINAL BLOCK MARKERS
quick start guide
Required Components
TDP43ME-TB-KIT
Width Guide Adapter Kit
TDP43ME Printer with roll
stand (TDP43ME-RS) and
resin ribbon
Easy-Mark Plus
TM
Labeling Software
step 1:
tdp43me f irmware update
• To print terminal block markers you must have TDP43ME printer firmware version
G3.0AP1 or newer
• To check version, press and hold the FEED button while turning the printer on. Keep
holding FEED until first 3 beeps, then let go of button.
• Self-test will print automatically, showing version number next to “TDP43ME”
(For more details see section 3-3 of TDP43ME user manual)
• If you have version G3.0AP0 or newer, proceed to step 2 below
• To upgrade your firmware, visit www.panduit.com/FirmwareUpdate
• Open the downloaded .zip file, and doubleclick on the DownloadTool 1.7.0.0f.exe file
• Click on Download Firmware
• Click on the .BIN file to highlight and select
• Click Open, printer should automatically begin firmware installation and reboot
step 2:
INSTALL EASY-MARK PLUS
tm
labeling software
If you have already installed Easy-Mark Plus
TM
Labeling Software, then proceed to Step 3.
Existing Easy-Mark
TM
users:
- Visit www.panduit.com for a free upgrade to Easy-Mark Plus
TM
New Easy-Mark
TM
users:
- Install Easy-Mark Plus
TM
that is provided with your TDP43ME printer
step 3:
Width guide Installation
Align right “R” width guide insert into
green printer guide as shown above
Use thumb to press insert horizontally
into guide, until insert snaps into place
Repeat installation for left “L” side
Use fingers to widen guides
by pressing out
Use tabs on width guides to press
guides inward as needed
When changing from terminal block mark-
ers to other types of labels, use the rear
tabs on the width guide inserts to lift and
remove them from the green printer guides
1
2
3
4
5
6
Contact Panduit Identification Technical Support with any questions.
[email protected] | 866-871-4571
