PVIQ™ CONNECTIVITY SYSTEM USER MANUAL V 1.0
27
Where <x> is the offset number of the panel.
To exit Learn Mode, and return to Secure Mode, using the CLI set mode command,
enter the command as shown below:
set mode <x> secure
Where <x> is the offset number of the panel.
Refer to the SmartZone Software User Manual to learn how to enter and exit Learn
Mode on the PViQ™ Connectivity Panel.
Maintenance Mode
Maintenance Mode is used for initializing and resetting the PViQ™ Connectivity System.
This Mode provides the capabilities to perform panel/tray reconfigurations, firmware
updates, system level technical functions, and troubleshooting procedures.
CAUTION: This section describes actions that can cause the PViQ™ Connectivity
System database to be cleared, losing all current configurations, provisioning and patch
field connectivity data. Use caution before attempting Maintenance Mode Resets
described here.
Identifying Maintenance Mode
In Maintenance Mode, the System Status Indicator LED (SYS), Trace Indicator LED
(TRC) and MAC Indicator LED (MAC) will all light solid green. The Mode Indicator LED
is off. The below figure shows the IU in Maintenance Mode.
Figure 24: Maintenance Mode
In addition, all port LEDs will light solid red and an audible beep will continue to sound
every 15 seconds.
Entering and Exiting Maintenance Mode
Maintenance Mode may be entered by the PViQ™ Connectivity PM IU (refer to
