© Panduit Corp. 2018
OPERATION MANUAL
CT-930LPCH &
CT-940CH/BJO
CT-930LPCH_CT-940CH/BJO: PA29199A01_00
Page: 5 of 9
6-2018
IMPORTANT INFORMATION
•
Keep the tool head portion clean and free from debris. Excessive dirt and grit can contribute to the
premature wear of the tool’s internal mechanical parts. When not using the tool, regularly check that
no foreign matter or debris exists in the open areas between the indenters in the tool head.
•
Soap and a damp cloth should be used to clean the tool body.
•
Always store the tool in its clean, dry carrying case when not in use.
•
DO NOT
press trigger and release button simultaneously. Damage to trigger linkage may result.
•
Always point tool away from others.
•
If the tool is kept in cold temperatures below 23
o
F/-5
o
C for any extended time, it is advisable to return
the tool to room temperature for 1 hour before using.
•
Avoid dropping the tool. Extreme shock may damage the hydraulic circuit and result in malfunction
of the tool.
•
Always verify the proper size compression connector for the conductor, by checking the color code
and the printing on the compression connector.
DIE SELECTION
Match index number and color on die
(see Figures 1 and 2 on Page 5 and Page 6)
to index number and
color band on compression connector.
NOTE: CONNECTIONS UTILIZING THIS TOOL ARE U.L. LISTED AND C.S.A. CERTIFIED ONLY
WHEN PANDUIT COMPRESSION CONNECTORS ARE USED. USE OF ANY OTHER
BRAND OF COMPRESSION CONNECTORS IS NOT RECOMMENDED.
Consult product packaging, Panduit catalog or website for information on recommended compression
connectors.
DIE IDENTIFICATION FOR USE WITH MATCHED COMPRESSION CONNECTOR
1.
Always verify correct die set by die part number.
2.
Color coding dot for verification may be found near die crimp pocket.
FIG. 1
CD-920 SERIES DIES
